Enerscan’s Cable Restraint Insulator enables holding conductors (including HUGE diameter conductors) captive on a pole, in Unistrut or on any flat or curved surface. This enables an installation to look neat and tidy and facilitates repairs or maintenance should they be needed. The bottom half is easily secured in place by bolts or lag screws. Two retaining pins twist to enable the top half to be removed so conductors can be held in place, captive, by the top half once it is replaced and the pins are twisted. Interference fitting between the pins and the top and bottom facilitate keeping the pins in place though a cable tie through the hole in the end of each pin is recommended, to ensure the pins do not twist following the installation.

Application: Used to fix piping into place. Available in several sizes.

Application: Used to fasten conduit to poles or structures.

Application: Used to protect utility poles. Works by covering the end grain to prevent water and bird droppings from saturating and rotting the wood.

Application: Used as a spacer for triplex and quadruplex. Also used as a standoff spreader bracket for service take-offs. Components meet CSA standards.

Application: For use in open wire secondary systems as a spreader or for mid span taps.

Application: These polymer spool insulators are suitable replacements for any porcelain 53-1 or 53-2 insulators.

Application: For protection of ground wire.

Application: Insulator for a variety of cable racks. Other sizes and shapes available.

Application: Used with a 53-1 insulator (either porcelain or polymer as seen here).

This product was designed and is manufactured by Enerscan for Hubbell Power Systems. Hubbell Power Systems distributes this product throughout North America and overseas.

Application: This product replaces any service spool insulator and clevis combination or porcelain service anchor. Available with a variety of lag screw and machine bolt lengths.

Application: For use in open wire secondary systems as a midspan spreader, or, for mid span taps, where positive clamping to the secondary is required. Accommodates most wire sizes.

Application: For maintaining spacing between conductors on long spans or for prevention of flashovers caused by wind, ice or aging insulation.

Application: For use as a spacer for triplex and quadruplex.

Application: Used as a spacer for triplex and quadruplex. Also used as a stand off spreader bracket for service take-offs.

Application: Used in open wire secondary systems as a spreader or for mid span taps.

Application: For maintaining spacing between conductors on long spans or for prevention of flashovers caused by wind, ice or aging conductor insulation.

Application: Replaces the standard 53-2 spool insulator and clevis.

Application: For installation inside any line bucket. Supports the hose and hose bag.

Application: For installation inside any line bucket. Provides a convenient and secure location to store drills.

Application: For installation inside any line bucket. Provides a convenient and secure location for chainsaw storage. This product was developed by Enerscan to meet the needs of a Utility company for an Original Equipment Manufacturer.

Application: For installation inside any line bucket. Provides a convenient and secure location for tool storage.

Application: For installation inside any line bucket. Designed as a complement to the Tool Rack and Service Tool Rack.

Application: For installation inside any line bucket. Tool holders ensure ready access and save time.